Standard Interpretations
OSHA requirements are set by statute, standards, and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additional employer obligations. Each letter constitutes OSHA's interpretation of the requirements discussed. Note that our enforcement guidance may be affected by changes to OSHA rules. Also, from time to time we update our guidance in response to new information.
- 1926.302 - Fasteners used in tools shall be only those specifically manufactured for use in such tools. - 03/02/1982
- 1926.302 - Guarding requirements for a rotary pneumatic angle-drive hand-held tool. - 12/11/2001
- 1926.302 - Laboratory testing requirements for hand-held electrical construction tools. - 12/12/1986
- 1926.302 - Pneumatic tools must be designed and used in accordance with good engineering practices - 04/08/1982
- 1926.302 - Pneumatically operated staplers. - 05/14/1979
- 1926.302 - Repair requirements for the cord plug (attachment plug) of double-insulated tools. - 05/19/2003
- 1926.302 - Statement of compliance from OSHA for a pole-mounted powder actuated tool. - 09/05/1995
- 1926.302(a) - All electric tools need to be tested by a qualified national testing laboratory and be listed and labeled - 01/28/1994
- 1926.302(a) - Marking recognition, regulations and policy of double insulated power tools - 11/08/1985
- 1926.302(a) - Repair requirements for the cord plug (attachment plug) of double-insulated tools. - 05/19/2003
- 1926.302(a)(1) - Repair requirements for the cord plug (attachment plug) of double-insulated tools. - 05/19/2003
- 1926.302(b)(10) - Whether an abrasive blast cleaning nozzle can use a mechanical device to keep the valve in the open position. - 05/30/2012
- 1926.302(b)(3) - Applicability of 1910.212(a)(3)(ii) to Portable Pneumatic Powered Fastener Tools - 03/25/1985
- 1926.302(b)(4) - Use of compressed air above 30 p.s.i. for cleaning purposes;nonmetallic-sheathed cable for temporary wiring. - 10/04/2000
- 1926.302(c) - Standards applicable to Bell Industries "Carb-Cutter" powered tool. - 06/05/1985
- 1926.302(e) - Training requirements for powder-actuated tools under §1926.302(e). - 03/10/2006
- 1926.302(e)(1) - Training requirements for powder-actuated tools under §1926.302(e). - 03/10/2006
- 1926.302(e)(5) - When magazine-fed tools are inspected, the tool is not considered loaded until the magazine feeds the tool. - 09/02/1975
- 1926.302(e)(6) - When magazine-fed tools are inspected, the tool is not considered loaded until the magazine feeds the tool. - 09/02/1975
- 1926.302(e)(7) - Interpretation on the use of power activated fasteners being driven into ductile cast iron ingot molds. - 07/25/1979